Meridian Spas: Pedicure Chairs & More

Pedicure Spas
Pedicure Chairs
Pedicure Benches
Portable Pedicure Spas
Pedicure Sinks
Massage Chairs
Pedi Sink Faucets
Pedicure Carts
Pipefree Whirlpool Systems
Disposable Liners
Pedicure Chair Accessories
Pedicure Chair Parts
Manicure Stations
Manicure Tables
Manicure Bars
Nail Drying Stations
Nail Salon Equipment
Table Parts
Nail Polish Racks
Salon Furniture
Styling Chairs
Shampoo Chairs & Bowls
Styling Stations
Salon Reception
Barber Chairs
Salon Privacy Dividers
Chairs & Stools
Spa Decor
Salon & Spa Equipment
Salon & Spa Tables
Vichy Showers
Wet Tables
Spa Loungers
Massage Therapy
Massage Therapy Chairs
Massage Tables
Headrests
Company Info
Contact Us
Terms & Info
FAQ's
Site Map




Home
Call To Order 1-866-730-SPAS
Shipping
Finance
email

Catalog
International
Downloads
Portfolio
Home > Pedicure Chair Parts > Cleanjet Max Plastic Bushing

Cleanjet Max Plastic Bushing Replacement

Plastic Bushing Five Pack
Sold in packs of 5
Clean Jet Max Cover With Bushing
Step 1. Pull CJ Max Cap from the pedicure bowl.
Step 2. Remove Banana plug by simply pulling it from the cap.
Step 3. Turn the CJ Max Cap cover counter-clockwise (below the silver tab and banana plug hole are arrows)
Step 4. Remove magnetic puck and turn the CJ MAX Cap heavy base upside down on a flat, sturdy surface.

Push out bushing
Step 5. Using a solid, sturdy object (such as a pen or screwdriver) push the bushing out from the cap's base as per the accompanying picture. Always use care and caution when using any kind of tool or instrument.

Insert new bushing
Step 6. Insert the new bushing so that the narrow end of the bushing is pushed through to the back of the back plate, leaving the flat, wide end of the bushing on the top portion of the back plate (see image) Gently tap the bushing to secure it to the base.

Reassemble
Step 7. Reassemble the Clean Jet MAX Cap. Place magnetic puck back into heavy base.
Replace the cap cover by placing the banana plug hole on the cover slightly to the left of the banana plug hole on the base. Turn the cap cover clockwise so the banana plug holes are aligned. Insert the banana plug

Return cap cover to spa
Step 8. Place CJ MAX Cap back onto spa base so that the outer tab is pointed upward.


Clean Jet Max Maintenance Notes:


- With water in the bowl about 1 – 1 ½” above the retainer plate – on side of bowl, align the cap over the 3 white pegs on the retainer and secure.

-Push the jet button to start the whirlpool. (*Jet motor and cap should not run dry*) The motor has a magnet inside of it as does the cap, as soon as the cap is in place and the motor turned on, the magnetic force between the 2 magnets will cause the magnetic ‘puck’ to spin inside the cap creating the whirlpool effect.

-The ball bearing on the back of the magnetic ‘puck’ spins on the bushing and over time will wear the little bushing down, bringing the magnetic puck closer to the back cover of the cap, causing the process to either slow down, make a noise (as it will be hitting the back cover of the cap) or stop.

-The little bushing should be replaced about every 3 – 5 months depending on usage, if needed.















::
::
::


Copyright 2017 Meridian Pedicure Spas